Remote Start Not Working After Car Battery Change. Make sure that the connecting harness is fully secured. If you have recently changed the battery of your fob remote car starter or if it has ceased to work it may have fallen out of sync and needs to be reset or reprogrammed.
Disable the alarm by removing the alarm fuse, and then bring the car to the shop. Let go of the brake and it will ask you to touch your key fob to the start/stop engine button. Make sure that the connecting harness is fully secured.
Table of Contents
Turn The Key To Off Position.
The antenna/transmitter light won't turn on and the led's on the alarm brain and bypass are not lit up. Thereof, how do i reset my car alarm after changing the battery? After replacing the battery in the key fob remote, you will need to reprogram the remote to the vehicle.
Press The Lock Button Twice On Your Remote.
If your key does not work after changing the key fob battery, here are some possible causes. The vehicle cannot be started with the fob in the car. Something wrong with battery electrical contact points.
Look On The Back Of Your Remote For The Proper Buttons To Press To Enter And Exit Valet Mode (Usually Lock+Trunk).
Why did my remote start stop working? You would do this when having service done to your vehicle. It should be near the drivers side hood hinge.
Insert Your Key Into The Ignition Turn It To The On Position — Right Before Actually Starting The Car, The Lights Should Turn On.
Press and hold the lock button on your fob remote car. If your car key remote works after replacing the battery, then you're done. Check the remote antenna inside of your vehicle.
'I Disconnected The Car Battery/Changed The Car Battery And Now My Car Won't Start' Another Common Question On Fixya.
Also know, how do you reset a key fob? Press and hold the lock button on your key fob while you press the brake and start button as if you were starting your car normally. The remote lock/unlock functions do not work and when i try to remote start w/2way fob it sends signal but does not return any error code or anything.