How To Program Liftmaster Garage Door Opener To Car. Once the button is pressed, there is approximately 10 seconds in which to initiate the next step. Press and hold the # button until the garage door opener light blinks twice.
Locate the learn button on your garage door opener. Press and release the “learn” button. There are two buttons on the homelink system, press and hold them until led starts to blink.
Table of Contents
Within 30 Seconds, Press And Hold The Homelink Button In Your Car.
Find out if you need a bridge. Press and release the learn button on the garage door opener. You will also need a step a ladder.
Start With The Garage Door Opener Lights On.
Holding the homelink button will connect the car to the machine's signal. You’ll need it to program your car to work with the opener. Connect your car and home with homelink® and liftmaster® homelink offers seamless and convenient integration to control your liftmaster garage door openers and gate operators.
First, Press The Learn Button On The Back Of Your Garage Door Opener Mounted On The Ceiling.
Within 30 seconds of pressing the learn button, press and hold the button you wish to program on the remote control for three seconds, then release. Or you can use an electronic keypad to control the door without a remote. Holding the homelink button will connect the car to the machine’s signal.
Repeat Press/Hold/Release Until The Door Is Activated.
Within 30 seconds, press and hold the homelink button in your car. Note you should do this until the door starts operating. Holding the homelink button will connect the car to the machine's signal.
Press And Release The Learn Button.
(upon pressing the light button, the lights will immediately turn off and come on. Holding the homelink button will connect the car to the machine’s signal. Place your step ladder beneath your garage door opener and climb.