How To Install Shower Base Drain On Concrete Floor. How to install shower base drain on concrete floor. Such a setup pumps the water from the shower into your home's main drain.
In a home where the main drain is above the basement floor level or in a basement with no basement drain provisions, you can still add a shower without breaking any concrete. This video from bunnings will show you in just a. Apply primer and cement to the drain pipe and the flange.
Table of Contents
In A Home Where The Main Drain Is Above The Basement Floor Level Or In A Basement With No Basement Drain Provisions, You Can Still Add A Shower Without Breaking Any Concrete.
Fill in the hole around the shower drain with dirt or concrete. Remove the bolts so that you can remove the top of the drain, known as the drain cover, separating it from the flange and the actual drain attachment. How to install shower base drain on concrete floor.
Mark X On Floor At Center Of 2” Pvc Drain Pipe Of Shower Base And On The Right And Left Sides Where The Front Of The Base Will Be Located.
But before installation, you have to buy shower base. Make sure that the drain is level before securing it in place. How to install shower base drain on concrete floor.
You Can Purchase An Elevated Shower Base Or Frame One From Treated Lumber.
Next, attach the drain body through the shower base and place the base on the concrete, so the drain body goes into the drain pipe. Begin by applying the portland sand cement mixture bed over a subfloor pitched at a ¼ inch per foot slope or 2% grade. Fiberglass type of stall should work just fine in this type of setting.
If You Can Access The Bottom Of The Floor From Elsewhere, Like The Side Or Even The Bottom, Just Drill Or Chip A.
This procedure is very simple and convenient to hook up a shower basement without destroying the concrete flooring. This setting can be easier said than done, but here are some detailed instructions that should help you out. Apply primer and cement to the drain pipe and the flange.
The Hole Should Be Big Enough For The Shower Drain To Fit Into.
The drain system must slope from the shower, or other plumbing fixture, down to the home's septic tank or sewer system. Including the 1/8” gap from the rear and I hope to use a moulded shower base.