How To Install Furnace Filter Correctly. In this case, the unit is located in the mechanical closet, just off the garage. Why it's important to install a new air filter correctly near the coachella valley.
We'll show you which direction to install your air filter and what can happen if it’s installed the wrong way! Other furnaces might require you open a panel to access the filter. How you install a furnace filter will depend in part on how the filter is attached.
Table of Contents
A Filter Incorrectly Put In Can Restrict The Flow Of Air And Force The Furnace To Work Too Hard.
In this case, the unit is located in the mechanical closet, just off the garage. I'll guide you through all that you need to know to do the job right. And so i’ve actually already taken out the old one.
Once The New Filter Is In Place, Turn The Furnace Back On And You’re Finished!
The arrow must always face toward the furnace and away from the return duct. Close the return grille or door and latch. You can see right here is the furnace indoor cooling coil.
If Not The C Wire Is Not Working.
Make our way to the unit. Slide the new filter in with the arrow pointing toward the furnace. Believe it or not, there is a right way and a wrong way to change your furnace filter.
Once You’ve Found The Right Direction, Insert The Furnace Filter With The Arrow Facing Towards The Furnace And Away From The Return Duct.
In most furnaces, the filter is located where the ductwork meets the furnace or adjacent to the furnace. But if your filter is installed in the wrong direction (a mistake that can. Why it's important to install a new air filter correctly near the coachella valley.
After Identifying Whether Your Furnace Needs A Filter Change, Follow These Steps To Install Your Filter Correctly:
Make sure the “airflow’ arrow is pointed towards the return or towards your furnace. Ensure that the box is the right size for the filter to be installed. The pleated part of the air filter should be facing you when you install it and the other side, which usually consists of a metal mesh or cardboard frame should be pointed towards the return.