# How Much Ground Does A Yard Of Concrete Cover

How Much Ground Does A Yard Of Concrete Cover. There are many kinds of cement but portland cement is the most common. Calculate the volume of concrete you need in cubic yards.

20 feet x 35 feet. The formula for cubic yards is this: Total square footage x desired depth / 324 = cubic yards needed.

### Currently Back Slope Is 26″ In 45′.

1 yard @ 2 will cover 162 square feet. A cubic yard of concrete will cover 100 square feet x 3 inches deep or 27 cubic feet. The weight of concrete is determined by its density, which can vary based on the amount of aggregate, water, and air in the mix.

### Multiple Factors Go Into Concrete Prices, Including The Size Of The Area You Want To Cover And The Concrete Thickness.

One ton of sand covers about 80 to 100 square feet. $$volume = area \times depth = 100 ft^2 \times 3\,in = 25\,ft^3$$ I have run a string line and from one side set at 4″ to other side is 22″ ( this is 55′ wide).

### Let’s Say I Have An Area Of 100 Ft² That I Want To Cover With Sand To A Depth Of 3 Inches.

A yard of sand weighs approximately 2,000 and 3,000 pounds, or about 1 1/2 tons. Also question is, how much area does a yard of gravel cover? This same principle applies when dealing in metric.

### The Following Calculator Helps Estimate The Amount Of Gravel Needed To Cover An Area Based On The Density And Desired Depth Of The Gravel.

Your final cost will depend on the slabs size, thickness, and if you any special reinforcement such as wire mesh or rebar. It is easiest to use one of the many online topsoil calculators. The national average cost of concrete installation ranges between roughly $3 and$10 per square foot or $109 and$159 per cubic yard.

### I Want To Go With A 1″ Slope Every 10′ Distance.

Ground covers add to the plant palette. How much is a ton of sand? In a perfect universe, our 1,080 square foot driveway will need exactly 16.62 cubic yards of concrete (1,080 square feet / 65 square feet equals 16.62 cubic yards).